Velocity RDA v2

Velocity RDA v2 by Insignia Design Group

The Velocity RDA ™ is a joint collaboration effort between Cisco (AvidVaper) and Dino. Based off a dual screw two post-covering design Cisco has had on paper for a while and a collaborative effort in air flow and cap design between Cisco and Dino (Insignia Design), The Velocity ™ was born. The Velocity ™ is a unique design full of groundbreaking features. With infinite air flow adjustments and endless coiling options, there is no limit to the possibilities. The large deep well, dual screw two post design opens up enormous coiling options for exotic coil builds and temp control Ni / Ti builds. Fully adjustable horizontal direct H slots feed air to even the most demanding coil as well as flavor chasers. Six fully adjustable indirect intake holes bring in additional air to help cool hot builds. The Velocity's unique two post open deck design shoulderstand satisfy even of the most seasoned vaper. From flavor to vapers volume vapers and everything in between !!

The V2 has some improvements from the original design :

- Shorter 510 threads for safer hybrid setup
- Convertible bottom feeding pin
- Thicker negative / positive posts
- Larger post holes
- More efficient Indirect Airhole placement
- Double notch for locking tab
- Cap alignment registration marks
- Thicker primary cap
- 3mm shorter profile
- Smaller chamber 

Specs :

- 304 stainless steel
- 510 threading 
- 22mm outside diameter
- 25mm overall height w / o drip tip
- Two post design
- Dual screw positive / negative posts
- Unique side mounted post screws
- Offset positive post (no center post)
- Convertable Bottom Feeding Pin (shiips plugged)
- High temp PEEK insulators (replaceable)
- Large diameter 5.75mm deep open liquid well
- Split cap design
- Infinite direct / indirect air flow adjustment options
- Dual 2mm x 8mm H-slots (horizontal slots) for direct air flow
- 6 x 2mm fully adjustable indirect air holes
- Double o rings for a firm primary cap seal
- Primary cap lock tab for precision air slot alignment
- Custom threaded large 12mm bore drip cap (no orings / no friction fit)
- Custom threaded 510 drip tip adapter
- CNC engraved serial numbers
- Brushed stainless finish
- Bottom feeding convertable

includes :

- 1x Velocity Dripper
- 1x Delrin Wide Bore Drip tip
- 1x 510 Delrin Drip Tip adapter
- 4x Hex set screws (Installed)
- 4x Slotted set screws
- 4x Philips set screws
- 2x BF plug set screws (one Installed)
- 2x Hex key (.9MM - 1.5mm)
- 3x o rings (Red or Black Silicone Nitrile)